Service areas
Richmond Garage Door Pros runs repair and install calls from Richmond, TX out to Cumings, Pleak, Four Corners, Thompsons, and other nearby towns in the area.
Garage door services
What to expect
We're based in Richmond, TX, and every job starts with a truck leaving from here. When you call, we ask for your cross street or subdivision, the door's rough age if you know it, and what it's doing - won't open, came off track, making a grinding noise on the way up.
That tells us what to load before we drive out, whether that's a torsion spring set, a new logic board, or just a lube kit and a wrench. For towns close in, like Cumings at two miles or Bridlewood Estates at five, same-day usually works if we've got the part on the truck already.
Farther stops - Needville, Simonton, Kendleton, Brookshire, Arcola, East Bernard, Wallis, all around 14 to 18 miles out, or Bunker Hill Village and Piney Point Village near 19 - still get served, but we're honest that drive time gets folded into the schedule, so you may land later in the day than a Richmond address would.
We don't claim a shop or a crew sitting in any of these towns. We travel to them from Richmond. That's a different thing than being local to each one, and we'd rather say that plainly than let you assume otherwise.
Local housing
The area we cover isn't one housing era, it's a mix, and that mix changes what breaks. Across the 13 named communities we work in, most homes were built between 1972 and 2014, with the median build year landing around 1987. That's a 40-plus year spread, and it matters because a door installed in 1975 and one installed in 2010 fail in different ways.
The bulk of the stock, though, sits in that 1980s-90s band. Those houses tend to carry extension or early torsion spring setups with openers from the first wave of chain-drive units - parts that are getting harder to source new, and worth checking for wear even if the door still looks fine going up and down.
Newer sections of the service area, built closer to the 2000s and after, usually have steel panel doors on torsion hardware with sensor-equipped openers, so the common calls there run more toward sensor alignment, remote programming, or a cable that frayed early because of a rough install rather than age.
We can't tell you which bracket your own street falls into without seeing the door. But knowing the spread helps explain why the same complaint - 'my door won't close' - gets a different fix depending on which decade your subdivision went up in.
Pricing
We don't post a flat price list, because the job itself decides it - a broken cable on a lightweight door costs less than a full torsion spring conversion on a heavier panel door, and the parts gap between a 1980s build and a 2010s build is real.
What we can tell you is what the area itself looks like financially: median household income across the service area runs $72,853, and of the roughly 12,455 households here, about 8,495 are owner-occupied houses rather than rentals - which is most of who calls us, since landlords and tenants rarely make the call themselves.
Climate plays a smaller but real role too. This area sits in a moderate heat band rather than an extreme one, so we don't see the spring failure rates you'd get somewhere with brutal summer swings, but heat still shortens the life of plastic rollers and worn cables over the years.
One honest limit: if your door is old enough that the spring size or track width isn't something we carry on the truck, we may need to order it, and that adds a day or two rather than same-day. We'd rather tell you that up front than promise a fix we can't deliver that day.
Towns we serve
Questions
We're based in Richmond, TX and drive out to the surrounding towns listed on this page. We don't have a separate location or crew stationed in Cumings, Pleak, Needville, or any of the others - every job is dispatched from Richmond.
It usually comes down to when the house was built. The service area spans homes from 1972 to 2014, with most falling in the 1980s-90s range, and each era used different spring setups and opener types, so the same symptom can have a different cause.
We cover towns from Cumings at two miles out to Bunker Hill Village and Piney Point Village near 19 miles. Jobs farther from Richmond still get scheduled, just with drive time factored into when we can get there that day.
Only roughly. A broken cable costs less than a full spring and track job, and older houses sometimes need parts we have to order rather than carry on the truck. We'll give you a firmer number once we see the door.
Ready when you are
Richmond Garage Door Pros repairs and installs garage doors, springs and openers in Richmond, TX and the surrounding area.
